Surface Preparation: The substrate surface should be clean, dry, and free from any dust, debris, oil, or other contaminants. It may be necessary to use a wire brush, sandpaper, or other cleaning methods to ensure proper adhesion.

Drill Holes: Drill holes into the substrate at the desired locations and depths according to the manufacturer's instructions. The diameter and depth of the holes should match the specifications provided by the manufacturer for the specific anchor and adhesive being used.

Blow Out Dust: After drilling the holes, blow out any dust or debris from the holes using compressed air or a brush. This step is crucial to ensure a clean and proper bond between the adhesive and the substrate.

Mixing the Adhesive: Follow the manufacturer's instructions for mixing the chemical adhesive or resin. This typically involves combining a resin and a hardener in the correct proportions and mixing them thoroughly using a suitable mixing tool.

Injection of Adhesive: Insert the mixing nozzle into the drilled hole and begin injecting the adhesive into the hole. It is important to fill the hole completely while avoiding air pockets or voids. Slowly withdraw the nozzle while injecting the adhesive to ensure uniform distribution.

Inserting the Anchor: Immediately after injecting the adhesive, insert the anchor or threaded rod into the hole, rotating it slightly to ensure proper coverage and contact with the adhesive. Make sure the anchor is properly aligned and seated to the desired depth.

Curing Time: Allow the adhesive to cure as per the manufacturer's recommendations. This typically involves a waiting period during which the adhesive hardens and develops its full strength. Avoid any movement or stress on the anchor during this curing time.

Final Testing: Once the adhesive has fully cured, perform any necessary tests or inspections to ensure the anchor is securely bonded to the substrate. This may involve load testing or other methods to verify the strength and integrity of the connection.

It is important to follow the manufacturer's instructions and guidelines for the specific chemical adhesive being used, as different products may have variations in application procedures and curing times. Additionally, always wear appropriate personal protective equipment (PPE) when handling chemicals and follow all safety precautions to ensure a safe and successful chemical anchoring process.